4 Replacement Procedures 4.14 Robson card
4-42 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Installing the Robson card
To install the Robson card, follow the steps below and refer to Figure 4-24.
1. Insert the Robson card to the connector on the system board slantwise and press it to
connect firmly.
2. Push down the Robson card and secure it with the following screws.
• M2.0×4B BIND ×2
To Next Page
Loading...
