4 Replacement Procedures 4.19 Serial board
4-58 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Installing the Serial board
To install the serial board, follow the steps below and refer to Figure 4-35.
1. Connect the serial board FFC to the connector CN9620 on the back of the serial
board.
2. Set the serial board into the slot of the base assembly while engaging it to the hook.
3. Connect the serial board FFC to the connector CN9520 on the system board.
To Next Page
Loading...
