4.34 LCD mask 4 Replacement Procedures
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-107
Installing the LCD mask
To install the LCD mask, follow the steps below and refer to Figure 4-65 to 4-66.
1. Set the LCD mask to the hinge standing.
2. Lay the LCD mask down and secure it with the following screws.
CAUTION: When laying the LCD mask down, hold the LCD mask with the hinge and lay
them down carefully.
• M2.5×4B FLAT HEAD screw ×2
• M2.5×6C Tapping screw ×4
To Next Page
Loading...
