4 Replacement Procedures 4.36 Fluorescent Lamp
4. Separate the panel assembly and backlight unit.
CAUTION: Handle with care not to damage COF of S/D.
Panel assembly
Figure 4-80 Replacing 15.4-inch Samsung fluorescent lamp (WXGA) (4)
Installing the fluorescent lamp
The installing procedure of the 15.4-inch WXGA Samsung fluorescent lamp is the reverse of
the above disassembly procedure. Refer to figures 4-77 to 4-80.
1. Install the panel assembly on the backlight unit.
2. Install the top chassis on the molded frame.
3. Stick the yellow tapes, lamp-wire tape and bottom Al tape.
4. Stick the PCB cover.
4-122 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
To Next Page
Loading...
