4.36 Fluorescent Lamp 4 Replacement Procedures
4. Separate the panel assembly and backlight unit.
CAUTION: Handle with care not to damage COF of S/D and G/D ICs.
Panel assembly
Figure 4-84 Replacing 15.4-inch Samsung fluorescent lamp (WSXGA+) (4)
Installing the fluorescent lamp
The installing procedure of the 15.4-inch WSXGA+ Samsung fluorescent lamp is the reverse
of the above disassembly procedure. Refer to figures 4-81 to 4-84.
1. Install the panel assembly on the backlight unit.
2. Install the top chassis on the molded frame.
3. Stick the yellow tape, lamp-wire tape and bottom Al tape.
4. Stick the PCB cover.
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-125
To Next Page
Loading...
