Toshiba TSL3000 - Page 17

STE 80722
– 12 –
COMMUNICATION MANUAL
series Robot Controller
[06] Port number of destination
[E06] Port number of destination
{ IP0 }
= 1000
{ IP1 }
= 1001
{ IP2 }
= 1002
{ IP3 }
= 1003
This parameter specifies each port number that is used by the destination. This is
used in client mode only. This must match the port number used by the server at the
destination.
{IP0}
=(Port number of destination)
{IP1}
=(Port number of destination)
{IP2}
=(Port number of destination)
{IP3}
=(Port number of destination)
[E07] IP address of destination
[E07] IP address of destination
{IP0}
= 192.168.0.150
{IP1}
= 192.168.0.151
{IP2}
= 192.168.0.152
{IP3}
= 192.168.0.153