Toshiba TSL3000 - Page 18

STE 80722
– 13 –
COMMUNICATION MANUAL
series Robot Controller
This parameter specifies the IP address of the destination where each port is
connected. This is used in client mode only.
{IP0}
=(IP address of destination)
{IP1}
=(IP address of destination)
{IP2}
=(IP address of destination)
{IP3}
=(IP address of destination)
[E08] Robot community name
(Planned for use in function expansion)
[E08] Robot community name
= “NO1-TS3K”
This parameter specifies the community name of the network.
This is planned for usage when the Ethernet function is expanded.
[E09] DHCP
(Planned for use in function expansion)
[E09] DHCP
= 0
This parameter specifies if an address is obtained from the DHCP server.
This is planned for usage when the Ethernet function is expanded.