Archer C3200 AC3200 Wireless Tri-Band Gigabit Router
¾ Add a rule for 192.168.1.101
IP Range-Enter the IP address. The field can be single IP address or IP
address range according to your demands. When you configure the single
IP address, the computer with this IP address will get independent given
bandwidth. When you configure the IP address range, all computers in the
range will share the given bandwidth.
Port Range-Keep the default settings. The port arrange of TCP protocol or
UDP protocol.
Protocol-Keep the default settings. Or you can choose the TCP protocol or
UDP protocol or both of them.
Priority-Keep the default settings. You can change the value if you want to
first guarantee the bandwidth for one computer. The smaller value has the
higher priority.
Upstream/Downstream-Enter the bandwidth according to your division.
Check to enable this entry and click OK to save the settings.
¾ Follow the steps above to add a rule for the other computer. And then you
will get the following table.
- 24 -
To Next Page
Loading...
