Archer C3200 AC3200 Wireless Tri-Band Gigabit Router
achieved. To surf the Internet and visit my company’s network at the
same time, I need to configure the static routing.
How can I
do that?
1. Change the routers LAN IP addresses to two different IP
addresses on the same subnet. Disable Router 2’s DHCP
function.
2. Visit http://tplinkwifi.net, and log in with the password you set for
the router. Go to Network>Advanced Routing. Click Add to add
a new static routing entry.
3. Finish the settings according to the following explanations:
Destination Network: is the destination IP address that you want to
assign to a static route. This IP address cannot be on the same subnet
with the WAN IP or LAN IP of the router. In the example, the IP
address of the company network is the destination IP address, so here
enters 172.30.30.1.
Subnet Mask: determines the destination network with the destination
IP address. If the destination is a single IP address, enter
255.255.255.255; otherwise, enter the subnet mask of the
corresponding network IP. In the example, the destination network is a
single IP, so here enters 255.255.255.255.
To Next Page
Loading...
