TP-Link Easy Smart Switch - Appendix: Default PoE Parameters

Configuring PoE (Only for Certain Devices) Appendix: Default Parameters
User Guide 79
4
Appendix: Default Parameters
Default settings of PoE Config are listed in the following table.
Table 4-1 Default Settings of PoE Config
Parameter Default Setting
Global Config
System Power Limit 150.0 W
Port Config
PoE Status Enabled
Startup Delay Low
Interval Class 4
Default settings of PoE Auto Recovery are listed in the following table.
Table 4-2 Default Settings of PoE Auto Recovery
Parameter Default Setting
Global Config
PoE Auto Recovery Disabled
Port Config
Ping IP Address None
Startup Delay 60 seconds
Interval 60 seconds
Failure Threshold 5
Break Time 15 seconds
Status Disabled