TQ Aviation KTX2-F.0100
EASA.AP445 MAN
KTX2-F.A-MAN.0001.docx Page 19 of 74
© TQ-Systems GmbH. All information contained in this documents have to be treated strictly confidential. The transfer of presentations and know-how to third parties
requires the prior written consent of TQ-Systems GmbH.
2.1.2 Display Indications
Indication Meaning Remark
Transponder is transmitting
Mode-A/C
Replies on
Interrogations
Appears per reply and persists for
some time
Transponder is transmitting
Mode-S
Replies on
Interrogations
Appears per reply and persists for
some time
Transponder is locked by a
ground station and will be
directly addressed
Appears at every addressed reply and
persists for some time
ADS-B out Status Status of ADS-B transmission
Active Squawk Is shown at upper position
Battery power too low Appears above Standby-Squawk
Failure indication See 4
IDENT- Marking is transmitted
ID („Squawk Ident“) has been pressed
– active for 18s
Current Flight Level Flight Level (in 100ft steps)
Mode display
(STBY, ON, GND, ALT)
see chapter. 2.1.6 Transponder-
Modes
Standby-Squawk
Is shown at lower position.
Can be ex
changed with active Squawk
by pressing the UP/DOWN (“Change”)
button
Flight ID
Only shown if a Flight ID is configured
with a valid Aircraft Address
VFR indication Shown while VFR squawk is used
Transponder is in airborne mode
Only shown if Ground Switch support
is configured.
Transponder is in ground mode
Only shown if Ground Switch support
is configured.
Figure 3: Indicators
To Next Page
Loading...
Need help?
General
