TQ Aviation KTX2-F.0100
EASA.AP445 MAN
KTX2-F.A-MAN.0001.docx Page 47 of 74
© TQ-Systems GmbH. All information contained in this documents have to be treated strictly confidential. The transfer of presentations and know-how to third parties
requires the prior written consent of TQ-Systems GmbH.
Figure 35: Multiple Flight ID Selection Menu
Turn the rotary knob to select the desired Flight ID. Press the rotary knob to confirm the selection. The
transponder will then use the selected configuration.
Note:
If more than four Flight IDs are configured turn the rotary knob clockwise until the next page is shown. To
go back to the previous page turn the rotary knob counterclockwise.
3.4.3 Modify VFR
To configure the VFR squawk code “Modify VFR" and press the rotary knob. A submenu “Modify VFR” is
displayed.
Figure 36: Modify VFR Code Menu
To change the VFR squawk code perform the following procedure:
1. Press the rotary knob. The first digit of the standby squawk turns yellow.
2. Turn the rotary knob to change the value.
3. Press the rotary knob again to save the selected digit. The next digit turns yellow.
4. Repeat steps 2 and 3 until all four (4) digits are set to desired VFR squawk code.
To Next Page
Loading...
Need help?
General
