TQ Aviation KTX2-F.0100
EASA.AP445 MAN
KTX2-F.A-MAN.0001.docx Page 28 of 74
© TQ-Systems GmbH. All information contained in this documents have to be treated strictly confidential. The transfer of presentations and know-how to third parties
requires the prior written consent of TQ-Systems GmbH.
2.2.8
Adjustable
parameters in normal operation mode
Some parameters can be changed while in normal operation mode. The changes are effective
immediately after confirmation, but will remain only until the transponder is powered off.
Note:
To make changes permanently the parameters have to be changed in setup mode (see 3).
2.2.8.1 Flight ID
To modify the Flight ID press the ID button for at least 3 seconds.
Figure 12: Change Flight ID
The Flight ID can be adjusted in the same way as described in chapter 3.4.2.1.
Note:
The AA-Code is shown for information only and cannot be changed.
2.2.8.2 Brightness
To modify the display brightness and the button illumination press the VFR button for at least 3 seconds.
Figure 13: Change Brightness
To change the display brightness select “Display” and press the rotary knob.
Turn the rotary knob to change the value for brightness between 1 (lowest) to 5 (highest). Press the
rotary knob to save the new value.
To Next Page
Loading...
Need help?
General
