TQ Aviation KTX2-F.0100
EASA.AP445 MAN
KTX2-F.A-MAN.0001.docx Page 29 of 74
© TQ-Systems GmbH. All information contained in this documents have to be treated strictly confidential. The transfer of presentations and know-how to third parties
requires the prior written consent of TQ-Systems GmbH.
2.2.8.3 Button Config
To change the button illumination select “Btn-Mode” and press the rotary knob.
The button illumination has three (3) modes: Off, On and Auto.
Turning the rotary knob will change the mode. Press the rotary knob again to confirm the mode.
Depending on the selected mode further parameters can be configured.
2.2.8.3.1 Button Illumination Mode “Off”
If this mode is selected the button illumination is switched off. No further parameters can be configured.
2.2.8.3.2 Button Illumination Mode “On”
If this mode is selected the button illumination is switched on.
To change the illumination level select “Level” and press the rotary knob. Turn the rotary knob to change
the value between 1 (dark) to 5 (bright). Press the rotary knob to save the new value.
2.2.8.3.3 Button Illumination Mode “Auto”
If this mode is selected the button illumination is switched between a day and night setting depending on
the ambient light sensor. No further parameters can be configured.
The settings can only be configured in setup mode, see chapter 3.4.1.
To Next Page
Loading...
Need help?
General
