Printed in the Federal Republic of Germany TR-Electronic GmbH 2017, All Rights Reserved
01/26/2023 TR-ELA-BA-DGB-0026-04 Page 37 of 52
4 Installation
4.1 Basic rules
● Power and signal cables must be laid separately. During installation, observe the
applicable national safety and installation regulations for data and power cables.
● Separation respectively differentiation of the measuring system from possible
interfering transmitters.
● Observe the manufacturer's instructions for the installation of converters and for
shielding power cables between frequency converter and motor.
● To ensure safe and fault-free operation, the following standards and guidelines
are to be observed:
- IO-Link Design Guide, PNO Order-No.: 10.912
- IEC 60947-5-2, Low-voltage switchgear and controlgear
- EMC directive
● Upon completion of installation, a visual inspection with report should be carried
out.
To Next Page
Loading...
