52 BAS-SVX45F-GB
Configuring Tracer UC600 with Tracer TU
1. Open up a session of TGP2.
2. Select the point type from the left side bar; click and drag onto the editing space.
3. Right-click and then choose Block Properties from the menu. The Point Properties Dialog box
appears.
4. Use the check boxes to select either TOV or */**, depending on the point.
5. Click Save.
6. Continue to build the TGP2 program using the provided TGP2 Editor tools (Figure 28).
7. When finished, name and save your new TGP2 program.
Note: For additional information, see “TGP2 Applications Guide, BAS-APG008-EN”.
Figure 28. TGP2 program example
To Next Page
Loading...
