Trane Tracer UC600 - Page 51

BAS-SVX45F-GB 51
Configuring Tracer UC600 with Tracer TU
To create points for the */** function
1. Complete steps 1 through 6 as described in “To create points for TOV functions,” p. 50.
2. In the Reference dialog box, select mode from the Available Properties frame. Click OK.
3. In the Definition frame, select the Create an associated Multistate Input check box.
The required multistate input is automatically created (Figure 27).
4. Click Send to Device to send the new point configuration to the controller.
Enabling TOV and */** for TGP2 Programs
After creating points specifically for TOV and */** functions, you can now enable the points in the
TGP2 Editor.
To enable TOV and */** points:
Figure 26. TOV point configuration
Figure 27. */** point configuration
Select
“analog
value” from
the reference
dialog box.
Select this
check box
Select “mode” in
the reference
dialog box.
Multistates
for */**
mode.