66 BAS-SVX45F-GB
Commissioning/Troubleshooting in a Powered State
Commissioning/Troubleshooting in a Powered State
This section provides instructions for testing the Tracer UC600 points after making connection and
applying power (indicated in each figure by the terminal connector and the Tracer U600 label). The
step numbers or method numbers in each figure correspond to the information in each table. (Refer
to Table 2, p. 9 for a list of device connections.)
The following equipment is required in order to test inputs and outputs:
• Digital multimeter (DMM)
• Small flat-bladed screwdriver
To Next Page
Loading...
