Installation
RT-SVX21AC-EN 45
Space Temperature Averaging
(ReliaTel™ Only)
Space temperature averaging is accomplished by wiring a
number of remote sensors in a series/parallel circuit.
Using the BAYSENS016* or BAYSENS077*, at least four
sensors are required to accomplish space temperature
averagi
ng. See diagram below.
• Example #1 illustrates two series circuits
with two
se
nsors in each circuit wired in parallel. The square of
any number of remote sensors is required.
• Example #2 illustrates three sensors squared in a
series/parallel ci
rcuit. Using BAYSENS077*, two
sensors are required to accomplish space temperature
averaging.
• Example #3 illustrates the circuit required for
this
sensor. Ta
ble 13, p. 48 lists the temperature versus
resistance coefficient for all sensors.
Figure 70.
Electromechanical (with TBUE) control customer wire routing (10 ton high efficiency)
To Next Page
Loading...
