Trotec SP3000 - Page 40

SP3000
Technical Data
40 / 87 BA 8034_2.4_EN (12/2016)
www.troteclaser.com
Material
Cutting
Engraving
CO
2
CO
2
Additional

Wood


Mirror
-
-
Stone
-

Paper (white)


Paper (colored)


Food


Leather


Fabric


Glass
-

Ceramics
-
-
Cork


WARNING
Prohibited materials:
Carbon, polyvinyl chloride (PVC), polyvinyl butyral (PVB), polytetrafluorethylene (PTFE,
Teflon
®
), carbon fiber, beryllium oxide and materials containing halogens (fluorine,
chlorine, bromine, iodine and astatine), epoxy-based or phenolic resins
Take care when processing the following materials:
Manganese, chromium, nickel, cobalt, copper and lead. Any material with the naming
addition “flame-retarding” since it might contain bromine.
WARNING
Serious injury or material damage.
The use of prohibited or unreleased materials can cause serious injury or material
damage and will not be covered under warranty.
- Only use approved and released materials.
For any material not listed above please contact our application specialists or sales
office in your area.
We recommend performing a material processing test with the above mentioned
material, using the appropriate configuration.
Trotec assumes no responsibility for any consequences of laser processing in any
application, especially with medical or pharmaceutical applications.