Trotec SP3000 - Lens

SP3000
Appendix
86 / 87 BA 8034_2.4_EN (12/2016)
www.troteclaser.com
14.4 How to create a service file
1. Start JobControl
®
.
2. Position the job that may cause the error on
the plate.
This can be done by either:
double clicking on the job in the queue
single-clicking the job in the queue and
dragging it onto the plate
single-clicking the job in the queue and
then clicking on the icon “Position Job”
.
3. Run the job and leave the job on the plate.
4. Go to “Settings” > “Create Service File”.
5. The window „Save Service File to” shows
up.
6. Please select a directory to save the file into
and click on „Save”.