Trotec SP3000 Operation Manual

SP3000
Maintenance
78 / 87 BA 8034_2.4_EN (12/2016)
www.troteclaser.com
10 Troubleshooting
This chapter should enable the maintenance personnel to identify and resolve operational faults based
on error messages and symptoms.
DANGER
Risk of fire from incorrect parameter settings
Laser operation with incorrect parameter settings such as power settings, speed or
frequency can result in flame formation.
- Laser operation permitted only under supervision.
System failures that cannot be remedied can cause damage to the machine.
- Disconnect the machine from the mains and contact your local support team.
10.1 Errors, cause and resolutions
Problem
Possible Cause
Resolution
Too low engraving depth
 Imprecise focusing
 Dirty optics
 Check focus
 Clean optics
Blurred edges
 Imprecise focusing
 Check focus
Missing cut lines
 Zero passes in material
database
 Line thickness in Corel
Draw too big
 Color was skipped in
JobControl
®
 Increase the amount of
passes in the JobControl
®
material database
 Reduce line thickness to
smallest possible value
 Set color to cutting in the
JobControl
®
database
Waviness of the lines
 Lens is loose
 Check lens and lens holder
No visible marking result
 Too low laser power
 Too high speed
 Not focused
 Wrong focus tool
 Increase power setting
 Reduce speed
 Check focus
 Change focus tool
 When using Auto focus,
check the settings within
the software (lens, material
thickness, table)

Trotec SP3000 Specifications

General

Brand	Trotec
Model	SP3000
Category	Tools
Language	English