SP3000
Operation
BA 8034_2.4_EN (12/2016) 59 / 87
6. Turn the key switch clockwise and hold against the
spring force. As soon the machine is started, release
the switch. The switch returns to its initial position.
Only if the cooling system was switched
on beforehand, the safety circuit gets
closed and the machine can be turned
on.
7. The machine starts the referencing process approx. 25
seconds after switching it on.
8. As soon the referencing process is correctly completed
and an acoustic signal sounds, the machine is ready for
operation.
Additionally the ready-to-use state is indicated through
the slow flashing of the green status LEDs..
To Next Page
Loading...
