5. The distance between this spot and the rulers should be smaller than 0.5mm.
6. If the distance is bigger: between X ruler and spot ⇒ reduce X-offset until you are
within tolerance (Settings>Service settings [password „name“]>tab Offset),
between Y ruler and spot ⇒ reduce Y-offset.
7. If you hit into the ruler(s):Y ⇒ increase the X offset, X ⇒ increase the Y offset.
Note: If you can not reach the necessary position you have to move the rulers. Pleas
refer to the „ruler adjustment“ in this manual.
Steps for adjusting the Z offset:
1. Check if the table has been adjusted correctly.
2. Make sure that the selected plate material has been defined as 0mm thick.
3. Move the engraving head to 100/100 mm (Engraver>Move laser)
4. Hang the focus tool on the engraving head.
5. Click on „focus laser“ or select Engraver>Focus laser (top door must be closed).
6. The focus tool should gently touch the table.
7. If it drops increase the Z offset, if there is space between the tip and the
engraving table decrease the offset.
Note: If it is not possible to reach a satisfying result (because there is not enough
range of adjustment) you have to move the limit switches (especially the lower one,
as this is used for homing)
To Next Page
Loading...
Need help?
General
