NORMAL.DOT Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc Gespeichert am:2003/03/10
max Version 14
Seite 12 von 87
T H E U L T I M A T E M A R K
Dangers of Electricity
When you open the covers of the engraving system there is the danger to get in
contact with parts under high voltage. Therefore it is absolutely necessary that
service and repair work is only done while the power supply is unplugged. In any
case all safety laws and standards in connection with electricity must be obeyed.
IMPORTANT REMARK:
Usually you do not need to get in touch with the electrical and electronic
components. In case you do that when servicing or repairing the laser engraver,
please be sure that you first plug off the power supply.
To Next Page
Loading...
Need help?
General
