NORMAL.DOT Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc Gespeichert am:2003/03/10
max Version 14
Seite 13 von 87
T H E U L T I M A T E M A R K
Emission indication and safety labeling
Light Emitting Diodes
On the keypad of the laser engraver there is on the left side a red LED (light emitting
diode) which is illuminated when laser radiation is emitted.
If the service plug is used to defeat the door interlocks, the red LED close to the
service button is flashing (which indicates that the machine now is in service mode).
In this case the machine represents a laser class IV (4) product and special safety
provisions are necessary.
emission indicator
Audible Warning
When starting up the laser engraver without closing the cover there is an intermittent
beep. This indicates that the interlock system has not been checked yet. (You can
run the machine only if all interlock switches are closed). Close the cover of the laser
engraver to cause the machine to initialize.
On emitting a laser beam (which is called test pulse) by pressing the „TEST"- and
"SERVICE" button simultaneously there is a beep (as long as you keep the buttons
pressed) to remind you of the possible risks.
To Next Page
Loading...
Need help?
General
