Trotec Speedy C25 User Manual

NORMAL.DOT Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc Gespeichert am:2003/03/10
max Version 14
Seite 69 von 87
I N D I V I D U A L M A R K I N G S Y S T E M S
15. Network installation of Trotec laser engravers
Your Trotec Laser engraver can be installed also in a network. This will make it
possible to send jobs from any computer in the network to the job queue of the
computer that runs the laser.
You need:
• One computer to run the laser (and create jobs)
• Several computers to create jobs
Steps for creating a network installation:
1. Install the printer driver and the Trotec manager on all your computers.
2. Map on every computer (except the one that runs the laser) a network
drive to: Computer_that_runs_the_laser \ Hard _Disk_where_manager_is
_installed \ Directory_where_manager_is _installed
3. Alter in the trotec.ini file, which is located in the Windows directory of every
computer, the lines:
ArchivePath=C:\Trotec\Archiv\ to ArchivePath=Mapped Drive:\Archiv\
SpoolPath=C:\Trotec\Spool\ to SpoolPath=Mapped Drive:\Spool\
WorkPath=C:\Trotec\Work\ to WorkPath=MappedDrive:\Work\
ApplicationPath=C:\SPEEDY\ to ApplicationPath=Mapped Drive:\
The trotec.ini file looks like this:
[Status]
Running=0
[UserSetup]
ForwardToNet=0
IgnoreAbsWarn=0
CuttingBorder(mm)=1.0
VentDelay(min)=1.0
Tickle(0...255)=25
UseRotaryFixture=0
RotaryDiameter(mm)=63.0
UseInch=0
ZProgress(mm)=2.0100
CurrentUnit=0
LayerCount=64
Crosswise=0
LensIndex=0
ArchivePath=C:\Trotec\Archiv\
SpoolPath=C:\Trotec\Spool\
WorkPath=C:\Trotec\Work\
SerialPort=COM2
[AdvancedSetup]
RubberLevel1(%)=70
RubberLevel2(%)=30
TickleDelay(0...255)=2
PowerTestpuls(%)=10
LaserFrequency(Hz)=5000
MaxGraveVelocity(cm/s)=200
MaxCutVelocity(cm/s)=80
AccelSettingV(1)=1
AccelSettingK(1)=1
AccelSettingX(1)=9
AccelSettingY(1)=4
Language=1

Trotec Speedy C25 Specifications

General

Brand	Trotec
Model	Speedy C25
Category	Engraver
Language	English