EasyManuals Logo

Trotec Speedy C25 User Manual

Trotec Speedy C25
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
NORMAL.DOT Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc Gespeichert am:2003/03/10
max Version 14
Seite 50 von 87
I N D I V I D U A L M A R K I N G S
Y S T E M S
9. Special instructions for X-belt tensioning
Correct belt tensioning is very important for:
- obtaining good engraving results: Are the belts to loose quality of engravings can
be poor.
- life expectancy of mechanical parts: Is belt tensioning to high, mechanics like ball
bearings, belts, gears, will wear out quickly.
1. Disconnect the laser from mains.
2. Open right and left cover from the laser housing.
3. Remove cover from electronic compartment.
4. Check tensioning of x-gearing belt (small golden belt on the left side of x-axis) by
measuring the spring length of TENSIONING BOLT (Fig. 1).
Spring length should be 15 mm.
In case the spring length is incorrect proceed with following steps:
- Loosen MOTOR FIXING SCREWS (2 pcs.).
– Bring the spring to it´s correct length (and simultaneous the belt to the correct
tensioning), by screwing the TENSIONING BOLT in or out.
Tighten the MOTOR FIXING SCREWS.
– Re-check spring length again. If necessary repeat the tensioning process.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trotec Speedy C25 and is the answer not in the manual?

Trotec Speedy C25 Specifications

General IconGeneral
BrandTrotec
ModelSpeedy C25
CategoryEngraver
LanguageEnglish

Related product manuals