transmit
const TR_ERR TR_TRANS_JOBS_DIFFERENT = -216; // Jobs on platte
have different params
const TR_ERR TR_UPDATE_SETTINGS_CANCELED = -217; // canceld
update of settings
const TR_ERR TR_TRANS_SWITCH_FAILED = -218; // Switch of com
speed failed
const TR_ERR TR_NOT_IN_IDLE_STATE = -250; //
transmission should idle here
const TR_ERR TR_COMM_NOT_READY = -251; //
communication not ready
const TR_ERR TR_WRITE_DATA_FAILED = -252; // could not
write data to comm
const TR_ERR TR_DOWNLOAD_ABORTED = -300; // firmware
download aborted
const TR_ERR TR_DOWNLOAD_OPEN_FAILED = -301; // could not open
data file
const TR_ERR TR_DATAGRAM_TIMEOUT = -302; // no answer
for datagram
const TR_ERR TR_FATAL_RAM_ERROR = -303; // RAM error
const TR_ERR TR_FATAL_FLASH_ERROR = -304; // FLASH
error
const TR_ERR TR_RAM_CLEAR_ERROR = -305; // Could not
clear RAM
const TR_ERR TR_OPEN_JOB_FILE_FAILED = -800; // Could not open
job file
const TR_ERR TR_READ_BMPHEADER_FAILED = -801; // Could
read file header
const TR_ERR TR_WRONG_FILE_FORMAT = -802; // wrong
file format
const TR_ERR TR_COMPRESSED_DATA_NOT_SUPPORTED = -803; //
compressed data currently not supported
const TR_ERR TR_READ_BMPINFO_FAILED = -804; // Could read info
header
const TR_ERR TR_READ_CUTINFO_FAILED = -805; // Could read cut
info
const TR_ERR TR_SEND_QUERY_FAILED = -806; // Could
send query command
const TR_ERR TR_GET_INFO_FAILED = -807; // Got no
info from graver (timeout)
const TR_ERR TR_ERR_LOADER_SETMARK = -808; // SetMark of loader
failed
const TR_ERR TR_ERR_LOADER_OUTOFSYNC = -809; // loader is out of
sync
const TR_ERR TR_WRONG_COLOR_DEPTH = -810; // Wrong
color depth encountered
const TR_ERR TR_CREATE_BMP_FAILED = -811; // Could not
create bitmap
const TR_ERR TR_COLOR_TABLE_ERR = -812; // Error
retrieving color table
const TR_ERR TR_READ_TROTECINFO_FAILED = -812; // No trotec
info found
const TR_ERR TR_INIT_RUBBER_FAILED = -900; // could not
initialize rubber
const TR_ERR TR_INIT_BMPLINE_FAILED = -901; // could not
initialize bmp line
const TR_ERR TR_RUBBER_GETLINE_FAILED = -902; // could not
retrieve line from CRubber
const TR_ERR TR_JOB_INVALID = -903; // invalid (NULL)
job specified
const TR_ERR TR_MOVE_FILE_FAILED = -904; // move of