Prepare the site for measurement. Place the gauge near the core location
and press
〈START/ENTER〉. The display will be:
After counting down to zero, the display will be:
If more than one reading is to be taken, move the gauge to the next location
and press
〈START/ENTER〉. The gauge will repeat the above sequence
for each reading. When all the readings are completed, the display will be:
Press 〈START/ENTER〉 to return to the READY display. Thin layer
overlay measurements may be taken and stored at this time.
Reading # 1
Depth: BS
Time:xx sec.
WD:xxxxx
PCF
Move gauge and
press START
R
ea
ding(s
)-
xxxxx
PCF
Press ENTER
To Next Page
Loading...
