Troxler 3440 - Battery Monitor

Model 3440
6–25
SPECIAL FUNCTION
YES- Next menu
1- STAT TEST
2- DRIFT TEST
BAUD RATE
The speed at which characters are transmitted to a printer or computer is
determined by the setting of this special function. The baud rate is
normally configured at bps or bits per second. A speed of 300 baud would
then be approximately 300 bps.
Valid baud rates for the 3440 gauge are 300, 600, 1200, 2400, and 4800.
To execute the Baud Rate function, press
〈SHIFT〉 and 〈SPECIAL〉 for:
Press 〈YES〉 three times for the display:
Press 〈1〉 〈0〉 for the display:
Press 〈YES〉 to change the baud rate. The display will be:
Input the new baud rate and press 〈START/ENTER〉. After a few seconds,
the display will return to READY.
NOTE
If the wrong baud rate is entered, the error message –
ERROR– Illegal baud rate is briefly displayed. The gauge
then returns to the Do you want to make a change?
display shown above.
YES- Next menu
9- SET UNITS
10- BAUD RATE
11- COMM PROTOCOL
Baud Rate = 600
Do y ou wa n t to
make a change?
Baud rate = 600
I np ut ne w r at e.
Press ENTER
when
finished.
6. SPECIAL FUNCTIONS