Troxler 3440 - Precision

6–20
The display will be:
If the displayed value is correct, press 〈NO/CE〉.
Press 〈YES〉 if the value is to be changed. The display will be:
Press 〈1〉 to enter data with the keypad. The display will be:
Input the average measured density and press 〈START/ENTER〉. The
gauge will return to the READY display. Measurements may now be taken
and stored. These measurements should represent the density at or near the
core locations.
Core Density – Measurement Entry
From the Select method of... display above, press 〈2〉. The display is:
Input the number of readings to be taken and averaged. Press
〈START/ENTER〉 for the display:
Average measured
density-
x.x PCF
W an t to cha ng e?
S el ec t m eth od o f
Entering density
1 - Keypad
2 - Measure
Measured dens.-
x . x PCF
Press ENTER
when completed
# of Readings to
average (1-20)?
x
Press ENTER
- Reading # 1 -
Ti me : x m i n.
Set rod to BS &
Press
START