SPECIAL CALIBRATION
The Special Calibration function allows the operator to re-calibrate the
gauge constants temporarily for use in measuring particular materials.
These materials may be limestone or other materials that do not fall within
the range of a normal calibration. Once enabled, the Special Calibration
will remain in effect until the gauge is turned off or Normal calibration is
re-enabled.
To execute Special Calibration, press 〈SHIFT〉 and 〈SPECIAL〉 for:
Press 〈YES〉 two times for the display:
Press 〈6〉 for the display:
At this time, the operator may either enable an existing special calibration
or disable an existing calibration that has been in use. The operator may
also re-calibrate the gauge for use in a different material.
ENABLE SPECIAL CALIBRATION
Press 〈1〉 to enable the calibration. The display will be:
The gauge will return to the READY display.
YES- Next menu
1-
STAT TEST
2-
DRIFT TEST
6
-S
PE
CIA
L
C
AL
IB
.
7-
NOMOGRAPH
8-
P
RE
C
IS
I
ON
P
re
ss
:
1
-
e
na
bl
e
2- disable
3-
Rec
al
ib
.
CALIBRATION
ENABLED!
To Next Page
Loading...
