3–6
SPECIMEN HEIGHT
The Model 5850v2 can also compact the asphalt specimen to a
specified target height. The operator can specify a height of 50 to
200 mm. The final specimen height may vary slightly from the
value entered. Differences in specimen height are mix dependent. If
the height is not acceptable, modify the height set on the unit.
To set the desired specimen height, press 3 from the Change
Settings menu shown on page 3–4. The compactor displays:
Input Target
Specimen Height (mm)
115.0
Press <ENTER>
Use the number keys to enter the specimen height (50 to 200 mm).
Use the NO/CE key to backspace. Press ENTER. The display
returns to the Change Settings menu.
GYRATION ANGLE
The Model 5850v2 can be set to an internal gyration angle of 0.00
to 1.50 degrees. To set the angle, press 4 from the Change
Settings menu shown on page 3–4. The compactor displays:
Input Gyration
Internal Angle
1.16
Press <ENTER>
Use the number keys to enter the desired gyration angle (from 0.00
to 1.50 degrees). Use the NO/CE key to backspace. Press
ENTER. The display returns to the Change Settings menu
shown on page 3–4.
To Next Page
Loading...