Press 1 to enter the average of the four internal angle
measurements. The compactor displays:
Input Measured
Internal Angle
#.###
Press <ENTER>
Enter the measured angle and press ENTER. The compactor
displays the following (where #.## is the value just entered):
-Angle Offset-
#.## Degrees
1- Change
2- Enable
To enable the Angle Offset function using this value, press 2.
PRINT CALIBRATION
The Print Calibration function can be used to manually download
or print calibration data from the compactor. To use this function,
press 4 at the Calibration menu shown on page 4–5. The
compactor sends the calibration data to the selected output device
(see page 3–12), then returns to the Calibration menu.
To Next Page
Loading...