XRS2 and SRS2 EID Stick Reader
Issue 5, 03/2018
42
4 Refit the cradle into the case.
5 Ensure that all plastic swarf is removed from screw bosses.
6 Refit the two screws securing the cradle to the case front. If available, use a torque limited screwdriver set
to 0.5 Nm (4 lbf-in) once the screws has been seated by hand to prevent stripping of the screws.
7 Refit the main module. See page 37.
The LCD connector:
8 Reconnect the display FFC to the main module. Carefully lift the connector's retention flap to insert the FFC
cable.
9 Ensure that the FFC is fully engaged and straight before pushing down and engaging the connector's
retention flap.
10 Ensure that the Display FFC has been tucked in underneath the main module to prevent it from being
pinched when the case is closed.
11 Refit the antenna assembly. See page 36.
12 Close the case. See page 31.
13 Test the LCD. See page 27 .
To Next Page
Loading...