TRUE ICE truemfg.com
TEC_TM_171 | REV. G | EN
P#224534
02/28/2024 Page 52 of 72
Ice Machine Operation (cont.)
4. When "Would you like the unit to start making ice once
descaling and/or sanitizing is complete?" appears, press
either NO or YES. The ice machine will go into PRE-CLEANING.
5. Wait for the ice machine to run through the PRE-CLEANING
sequence (FILL, PUMP, DRAIN, and HARVEST). If there is enough
water in the sump at the start of CLEAN, it will go through
a DRAIN sequence before FILL. The compressor will start
during the HARVEST sequence to ensure there is no ice on
the evaporator and will shut off before the cleaning sequence
continues.
6. When ADD CLEANER appears, add the proper amount of
descaler or sanitizer as directed in "Descaling and Sanitizing
Procedures". Then press OK button.
NOTICE ›
The cleaning cycle will not proceed from this
point unless OK is pressed after adding the TRUE ice
machine descaler or chlorine bleach (5.25% sodium
hypochlorite).
7. Wait for the ice machine to complete the Descaling and
Sanitizing sequences. There will be a series of rinse, drain and
fill sequences during this time.
Cleaning Navigation (cont.)
To Next Page
Loading...
Need help?
General
