23
Function test
Check whether the battery is fully charged for operating the
Mover®XT L.
Position the caravan on open, level ground and apply the
parking brake. The drive rollers must not be in contact with
the wheels and the corner jacks must be raised.
Connect the battery terminals to the battery. Check that all
cables are securely attached and not hot, and that there are
no signs of short circuits etc.
Plug the 13-pin connector into the safety socket.
Move slide switch on remote control to the “On” position.
This switches on the remote control, and green LED 4 flashes
until the control unit is ready for operation. If LED 4 does not
light up, check polarity and condition of batteries in remote
control.
Check that neither drive motor is running. With the remote
control switched on, operate the “slide control (C)”. Both drive
motors must rotate.
Engage drive rollers using remote control.
Ensure that there are no obstacles around the caravan and
release the parking brake. Now check all functions several
times in accordance with the operating instructions.
Apply caravan parking brake. Disengage drive rollers and
move remote control slide switch to “Off” £ in order to switch
off the remote control and the Mover®XT L. Re-check dis-
tance between drive rollers and tyres. Re-adjust if necessary.
The distance between the disengaged drive rollers and
the tyres is 20mm.
Warnings
The installer or vehicle owner must apply the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, to a place in the vehicle where it is clearly visible to all
users (e.g. on the wardrobe door). Missing stickers are avail-
able from Truma on request.
To Next Page
Loading...
Need help?
General
