TSC ME240 User Manual

30
Press key to set the direction as 1, and to set it as 0, and key
to enable the setting. Press key to cancel the setting and return to the previous
menu.
The following 2 figures are the printouts of DIRECTION 0 and 1 for your reference.
DIRECTION 0
DIRECTION 1
Note: If printing from enclosed software/driver, the software/driver will send out the
DIRECTION 0 command, which will overwrite the setting set from the front
panel.
3.1.1-1.4 Print Mode: (None/Batch Mode/Peeler Mode/Cutter Mode/Cutter Batch)
This option is used to set the print mode. Printer default setting is Batch Mode. When enter
this list, the print mode in the right side of “ >” icon is the printer current setting. Press
and to select the different print mode and press button to
enable the setting. Press key to cancel the setting and return to the previous
menu.
Printer Mode
Description
None
Next label top of form is aligned to the print head burn line
location. (Tear Off Mode)
Batch Mode
Once image is printed completely, label gap/black mark will be
fed to the tear edge for tear away.
Peeler Mode
Enable the label peel off mode.
Print Setup 4/12
Density
Direction
>
Print Mode
Print Mode 2/6
>
Batch Mode
Peeler Mode
Cutter Mode

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)