TSC ME240 User Manual

36
3.1.1-2.1 Darkness:
Use this option to setup printing darkness. The available setting is from 0 to 30, and the
step is 1. Printer default density is 16.You may need to adjust your density based on
selected media.
Press and to increase/decrease the printing darkness. Press
key to enable the setting. Press key to cancel the setting and return to the
previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.2 Print Speed:
Use this option to setup print speed. The each increment/decrement is 1 ips.
Press key to raise the print speed, and press key to decrease print
speed. Press key to set it into printer. Press key to cancel the
setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.3 Tear Off:
This option is used to fine tune media stop location. Press the button to move the
cursor from left digit to right digit, and press the button to set the value from “+” to
Dankness
16
Print Setup 1/17
>
Darkness
Print Speed
Tear off
Print Speed
6
Print Setup 2/17
Darkness
>
Print Speed
Tear Off
Print Setup 3/17
Darkness
Print Speed
>
Tear Off
Tear Off
+000

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)