TSC ME240 User Manual

37
“-” or “0” to “9”. Press the button to set the value into printer. Press
key to cancel the setting and return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.4 Print Mode: (Tear Off / Peel Off / Cutter)
This option is used to set the print mode. Printer default setting is Tear Off. When enter this
list, the print mode in the right side of “ >” icon is the printer current setting. Press
and to select the different print mode and press button to enable the
setting. Press key to cancel the setting and return to the previous menu.
Printer Mode
Description
Tear Off
Next label top of form is aligned to the print head burn line
location.
Peel Off
Enable the label peel off mode.
Cutter
Enable the label cutter mode.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.5 Print Width:
This option is used to set print width. Press the button to move the cursor from
left digit to right digit, and press the button to set the value from “0” to “9” or “dot” to
“mm”. Press the button to set the value into printer. Press key to
cancel the setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
Print Setup 4/17
Print Speed
Tear Off
>
Print Mode
Print Mode 1/4
>
Tear Off
Peel Off
Cutter
Print Setup 5/17
Tear Off
Print Mode
>
Print Width
Print Width
812 dot

TSC ME240 Specifications

General

Resolution	203 dpi / 300 dpi
Operating Temperature	5°C to 40°C (41°F to 104°F)
Print Method	Thermal Transfer & Direct Thermal
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Humidity	20% to 85% RH (non-condensing)