TSC TDM-20 - Printer Initialization

38
5.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the printer.
2. Hold on the FEED button ( ) then turn on the printer ( ).
3. Release the FEED button when the indicator becomes and blinking.
(Any green will do during the 5 blinks).
 The LEDs will be changed as following order:
(amber)  (5 blinks)  (5 blinks)
 (5 blinks)  (solid green)
Printer configuration will be restored to defaults as below after initialization.
Parameter
Default setting
Speed
76.2 mm/sec (3 ips)
Density
8
Media Width
1.89” (48 mm)
Media Height
2” (50.8 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset
0
Code Page
850
Clear Flash Memory
No
IP Address
DHCP