43
WPA-Enterprise
Note:
* The default IP address is obtained by DHCP (Dynamic Host Configuration Protocol). To
change the setting to static IP address, select DHCP item to “OFF” then enter the IP address,
subnet mask and gateway.
* On DHCP, user can change the printer name by another model name in “Printer Name” field.
* User also can change the raw port in “Raw Port” field.
* Before setting, the entered field will be shown in yellow for reminding.
7. After clicking “Set” button, close this “Printer Configuration” setup page and click
“OK” button on “Confirm” window to reset the printer.
8. IP address will be shown in the “IP address” field. The Wi-Fi module has been
connected.
To Next Page
