To Next Page
K
Kathryn HarperSep 6, 2025
What to do if my TSC printer shows 'Carriage Open'?
- JJohn BushSep 6, 2025
If the LED indicates that the carriage is open on your TSC printer, ensure that the print carriages are completely closed.
What to do if my TSC printer shows 'Carriage Open'?
If the LED indicates that the carriage is open on your TSC printer, ensure that the print carriages are completely closed.
Why does the TSC TX200 Printer power indicator not illuminate?
If the power indicator on your TSC printer is not lit, ensure the power cord is correctly plugged into both the printer and the outlet. Also, make sure the printer is switched on.
What causes wrinkle problem on TSC TX200?
Wrinkling during printing on your TSC printer is often due to incorrect printhead pressure. Adjust the density setting to achieve good print quality.
How do I fix my TSC printer when it skips labels when printing?
If your TSC printer skips labels, verify that the label size is set up correctly. If the issue persists, calibrate the sensor using the Auto Gap or Manual Gap options.
Why is my TSC printer not printing?
Your TSC printer might not be printing because the interface cable isn't properly connected. Try reconnecting the cable to the interface or use a new cable. If you're using a serial cable, replace it with one that is pin-to-pin connected. Also, verify the baud rate setting, as the default is 9600, n, 8, 1.
What to do if my TSC Barcode Reader displays 'No Paper' or 'Out of Paper'?
If your TSC Barcode Reader displays 'Out of Paper' or 'No Paper': * Supply a new label roll. * The label may be installed incorrectly. Reinstall the label roll. * The gap/black mark sensor may not be calibrated. Calibrate the gap/black mark sensor.
What to do if my TSC Barcode Reader shows 'No Ribbon' or 'Ribbon End Err'?
If your TSC Barcode Reader displays 'No Ribbon' or 'Ribbon End Err': * Supply a new ribbon roll. * The ribbon may be installed incorrectly. Re-install the ribbon.
How to resolve gray line on blank label with my TSC Barcode Reader?
Gray lines appearing on blank labels from your TSC Barcode Reader can be due to: * A dirty print head. Clean the print head. * A dirty platen roller. Clean the platen roller.
What causes missing printing on the left or right side of TSC Barcode Reader label?
Missing print on the sides of labels from your TSC Barcode Reader is caused by: * Wrong label size setup. Set the correct label size.
What to do if my TSC Barcode Reader is continuously feeding labels?
If your TSC Barcode Reader is continuously feeding labels, it could be due to: * An incorrect printer setting. Initialize the printer and perform gap/black mark calibration. * Improper gap/black mark sensor sensitivity. Calibrate the gap/black mark sensor. * Incorrect label size setting. Ensure the label size is set correctly in the labeling software or program. * Labels stuck inside the printer mechanism near the sensor area. Remove any stuck labels.
General| Operating Temperature | 41°F to 104°F (5°C to 40°C) |
|---|---|
| Print Method | Thermal Transfer / Direct Thermal |
| Resolution | 203 dpi |
| Memory | 8 MB Flash |
| Processor | 32-bit RISC |
| Communication Interface | USB 2.0 |
| Core Diameter | 1" (25.4 mm) |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Storage Temperature | -4°F to 122°F (-20°C to 50°C) |
| Certifications | CE, FCC, RoHS, UL, TUV, CB, CCC |
| Operating Humidity | 25-85% non-condensing |
