TurboChef HIGH H BATCH 2 Service Manual

DIAGNOSING AN ISSUE
31
NO
YES
Replace the control
board. (page 39)
Correct wiring.
NO
YES
YES
Troubleshooting:
F8: HEAT LOW
YES
NO
Is the high-limit
thermostat tripped?
Is the blower motor moving air?
YES
Reset and determine
why it tripped – excess
grease buildup, etc.
(Figure 26, page 24)
NO
See page 28
to troubleshoot
F1: BLOWER
(Blower Running
Status Bad)
NO
Is the solid state relay
defective?
Is the heater element
defective?
Replace defective
heater. (page 43)
Verify the solid state
relay is not shorted
across output.
Replace the solid state
relay. (page 39)
Is wiring from the solid
state relay to the control
board OK? (See page 49 for
schematic.)

TurboChef HIGH H BATCH 2 Specifications

General

Brand	TurboChef
Model	HIGH H BATCH 2
Category	Oven
Language	English