Ubee Interactive Using the Port Filtering Option
Ubee DDW3611 Wireless Cable Modem Gateway Subscriber User Guide • November 2012 45
To set up IP filtering.
1. Make sure a PC is connected to the cable modem and both devices are powered on
and functioning.
2. Go to Tools > Client List in the Web user interface. Refer to Accessing the Web
Interface on page 17. Your PC and other devices are listed.
3. Note the MAC address and IP address of the devices to which you want to deny
Internet access. For more information, refer to Using the Client List Option on page 83.
4. Click Gateway from the main menu.
5. Click IP Filtering from the left side menu.
6. Enter the MAC address and IP address of devices to which you want to deny Internet
access.
7. Click Apply. Field descriptions are listed below the screen example.
5.10 Using the Port Filtering Option
Port Filtering allows you to configure port filters to block to all devices on the LAN
Internet services that use specific ports.
Label Description
Start Address Defines the starting IP address to filter.
End Address Defines the ending IP address to filter.
Enabled Activates the rule when enabled is checked.
Apply Saves all screen changes when clicked.
To Next Page
Loading...
