EasyManuals Logo

UFactory xArm 6 User Manual

UFactory xArm 6
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34
2.2.3. Specification of External Power
Input
Rated voltage
24V-28V
Rated power
400W
Rated current
17A
2.2.4. Electrical Alarms and Cautions
Always follow the warnings and cautions below when designing and installing a
robotic arm application. These warnings and cautions are also subject to the
implementation of maintenance work.
1. Never connect a safety signal to a non-safety PLC. Failure
to follow this warning may result in serious injury or death due
to an invalid safety stop function.
1. Make sure that all the non-waterproof equipment is kept dry.
If water enters the product, turn off the power supply, and
contact your supplier.
2. Use only the original cable of the robotic arm. Do not use
the robotic arm in applications where the cable needs to be
bent. If you need a longer cable or flexible cable, please
contact your supplier.
3. All GND connectors mentioned in this manual are only
suitable for powering and transmitting signals.
4. Be careful when installing the interface cable to the I/O of
the robotic arm.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UFactory xArm 6 and is the answer not in the manual?

UFactory xArm 6 Specifications

General IconGeneral
BrandUFactory
ModelxArm 6
CategoryRobotics
LanguageEnglish

Related product manuals