UNI-T UTD1025CL User Manual

UTD1000L User Manual
34
Measure Diode
To measure diode under the following steps:
1. Press key R the menu shall display the
measurement type resistance
2. Press key F1 the menu shall display the
measurement type diode
3. Insert blace table pen into COM banana
socket input port and red one into banana
socket input port
4. Connect the red and blace table pen with the
measured resistor the screen shall display the
turn on voltage drop voltage value reading of the
diode.
To conduct continuity test under the following
steps:
1. Press key R the menu shall display the
measurement type resistance
2. Press key F1 the menu shall display the
measurement type continuity
3. Insert blace table pen into COM banana socket
input port and red one into banana socket input
port
,
:.
,
:.
.
,
-
,
:.
,
:.
.
Ω
Ω
Continuity Test
Picture 5-2 Diode Measurement

UNI-T UTD1025CL Specifications

General

Brand	UNI-T
Model	UTD1025CL
Category	Test Equipment
Language	English