UniCarriers 2W1 Series - Putting Forklift in Storage; Daily Storage; Storage over a Long Period of Time; Pre-Storage Servicing

66
GENERAL CARE AND MAINTENANCE
PUTTING FORKLIFT IN STORAGE
Putting the forklift in storage involves storing the forklift at the end of
each working day or storing the forklift over a long period of time.
Be sure to observe the precautions for forklift storage.
DAILY STORAGE
At the end of the working day, check the forklift for oil leakage and other
malfunctions. Always park it in the designated location. Put chocks
under the tires to prevent the forklift from moving by itself.
Keep the body and areas surrounding the driver platform clean. Make it
a habit to always keep the forklift clean.
• The forklift has many electrical parts, do not wash with
water. However, the battery can be washed with water after
removing it from the forklift, but it must be completely dry
before use.
• Blow off dust and dirt using compressed air with OSHA air
nozzle or wipe with a wet cloth to clean the forklift.
• As soon as a malfunction is detected, immediately report it to
the appropriate personnel or contact your Local Authorized
Dealer for repair. Do not operate the forklift until the
malfunctions is repaired.
WARNING
!
!
CAUTION
!
STORAGE OvER A LONG PERIOD OF TImE
When the operation of the forklift is completely suspended for a given
period of time, take the following measures and store the forklift in a dry
area.
NOTE:
• When the forklift cannot be stored indoors, park it on level ground.
Cover with a waterproof sheet or protective cover.
• When storing for a long period of time, be sure to consult your Local
Authorized Dealer.
• Do not use a protective covering or waterproof sheet made
of vinyl which is liable to produce static electricity. Static
electricity may cause the battery to explode.
PRE-STORAGE SERvICING
1. Lubricate the forklift (refer to page 65). Change the oil and coat
all exposed areas of hydraulic cylinders with corrosion resistant
grease.
2. Charge the battery and leave it disconnected from the forklift.
Store the forklift in a low re-risk area.
SERvICING THE FORKLIFT IN STORAGE
1. Periodically check the specic gravity and level the battery uid.
Charge and replenish as necessary. Perform uniform charge on the
battery every 2 months.
2. Check various sections of the forklift for stains or corrosion. Clean
such areas and coat with a corrosion preventive agent.
WARNING
!
!