41
IGNITION SWITCH AND METER PANEL (cont’d)
OPTIONAL MULTI-FUNCTION LCD DISPLAY (cont'd)
Low Voltage Lock Warning
If the vehicle is subjected to
continuous operation after the
pump cut warning was activated,
the low voltage lock warning will
be activated. Then, the display
will appear as shown at right.
The vehicle cannot be operated
during the low voltage lock
warning.
NOTE: The interval between the rst appearance of the battery warning
mark and interruption of operation is dependent of the charge/condition
of the battery.
When a malfunction is indicated, immediately suspend forklift operation.
Contact your Local Authorized Dealer for inspection and necessary
repair.
WARNING
!
!
• When the malfunction is indicated, immediately suspend
forklift operation. Contact your Local Authorized Dealer for
inspection and necessary repair.
OPERATING CONTROLS AND FUNCTIONS
Exclamation Point
The controller and the sensors act together to regulate the forklift's
electrical system. Whenever one of the malfunctions listed below
occurs, the LCD will show and indication explaining the details of the
malfunction:
• Control system malfunction (Traction, Cargo-Handling, Power
Steering)
• Overheating Controller or Motor
OPERATOR'S PLATFORM - 2W2 ONLY
OPTIONAL EXTENDED OPERATORS PLATFORM
CAUTION
!
• The 2W2 models that have an optional extended operators
platform (as shown below) should not be used for loading or
unloading loads from docks to trailers due to the reduced
oor clearance. This may cause the unit to contact or stop
suddenly on the dock or bridge plate or even the trailer oor.
This action may cause the load to shift or become unstable,
damage the unit, dock plate or trailer oor, possible injury
to the operator or others in the area from the unstable
condition.
To Next Page
Loading...
